Shop by Category

Special DI box with loadbox for guitars. The integrated load resistor permits tube amplifiers up to approximately 120 W to be connected to the PGA04, bypassing a loudspeaker. A jack socket (unbalanced) and balanced XLR connector are available for direct...

Palmer Power Attenuator - Control the volume of your guitar amp The PDI06 is a power attenuator for live applications. The device is connected between the amplifier output and the speaker cabinet. It makes it possible to use the popular power stage...

Palmer Power Attenuator - Control the volume of your guitar amp The PDI06 is a power attenuator for live applications. The device is connected between the amplifier output and the speaker cabinet. It makes it possible to use the popular power stage...

With its flexible potential applications, the PDI-05 is equally at home in the studio and home recording as well as onstage, e.g., in the racks of Rush or Def Leppard. Originally developed for the preamp/multieffect/power amp combination popular in the...

The Palmer Speaker Simulator PDi 03 - available in 2, 4, 8 and 16 Ohm The PDI03 Palmer speaker simulator combines load impedance, a signal splitter and DI box especially designed for guitars. All functions are optimised for live and recording...

The Palmer Speaker Simulator PDi 03 - available in 2, 4, 8 and 16 Ohm The PDI03 Palmer speaker simulator combines load impedance, a signal splitter and DI box especially designed for guitars. All functions are optimised for live and recording...

Passive guitar amp DI box with speaker simulation   For live and direct recording applications   Consistent guitar tone in any venue or studio   Exclusive JB switch for a huge, maxed-out tone   Dual analog...

The Palmer Speaker Simulator PDi 03 - available in 2, 4, 8 and 16 Ohm The PDI03 Palmer speaker simulator combines load impedance, a signal splitter and DI box especially designed for guitars. All functions are optimised for live and recording...

The PMBL-ACTIVE is a 2-channel stereo line level merge box that can be used to merge two stereo line signals into one stereo output. One classic application: routing two mixing desks to one PA system. The unit has enough amplification to boost even...

The PAN-05 enables you to patch two microphones into one single mixing desk channel in situations where you run out of channels. Since decoupling occurs via a balanced resistor network, the PAN-05 also lets phantom power “pass through”,...

When I run my guitar into two amps simultaneously, I always get a loud hum". This is a rather common problem, often discussed in the technology section of relevant industry magazines. The Palmer Y box is the solution. Converting the hi-Z guitar signal,...