Replacement Tweeters

* 72mm Between Screw Hole Centers * Titanium cone * Mounting side diameter 125mm with cushioned surface * Takes large size horn flange or wave guide (not included) * 3-in Kapton High Temop Voice Coil * 80 Oz high Density Flux Ferrite Magnet * Frequency...

* Phenolic Replacement Diaphragm * Voice Coil: 2-in High Temp. Kapton * Coil Outside Diameter: 51.24 mm * Coil Width: 0.34 mm * Impedance: 8 Ohms * Compatible Driver: TBHDRIVER * Package: 126 x 106 x 36 mm * Package Dimensions: 4.96-in x 4.17-in x 1.4-in

* Titanimum Hard Dome Super Tweeter ideal for home speakers or mobile use. * Mounts from front or rear * Polished aluminum structure. * 1.7-in Titanimum Hard Dome w/3in center horn. * 21 Oz Magnet structure * 8 Ohm Impedance * Sensitivity: 104 dB * Freq...

* High Frequency Aluminum Tweeter * Diamond Chrome Cut Finish * 1.5-in High Temp. Kapton Voice Coil * 13 Oz Magnet structure * 200 Watts Peak Power, 40 Watts RMS * 8 Ohm Impedance * Ferro Fluid Enhanced Voice Coil * Sensitivity: 107 dB * Freq. Resp.:...

* Aluminum Replacement Diaphragm * Voice Coil: 1.5-in High Temp. Kapton * Coil Outside Diameter: 37.94 mm * Coil Width: 0.34 mm * Impedance: 8 Ohms * Compatible Tweeter: TBHTWEETER * Package 96 x 96 x 26 mm * Package Dimensions: 3.78-in x 3.78-in x 1...

Peavey Piezo Tweeter Piezo Tweeter Features Frequency Response: 4 kHz to 27 kHz Average Sensitivity: 94 dB 1 Watt / 1 meter Maximum Power Handling Capacity: 75 W (EIA RS426)(8 Ohm system reference) Maximum Voltage: 15 v rms continuous 35 v rms...

Peavey Triflex™ System Tweeter Triflex™ System Tweeter Features Nominal Impedance: 8 Ohm Output Sound Pressure Level: 107 dB Frequency Response: 1.5 kHz to 15 kHz D.C.R.: 6.8 Ohms Voice Diameter: 1" Diaphragm material: Phenolic Finish: ABS...

The Eminence PSD:3006 is a replacement high frequency compression driver with a 2" throat. It features a titanium diaphragm with a geodesic design, has a power rating of 80W and will handle an 8 ohm load.   Features 2" throat Titanium...

The Eminence ASD:1001 High Frequency Driver features a 1" (25.4mm) throat size and is intended to be installed into an exponential, radial or constant directivity horn flare. The horn flares themselves (with provided mounting holes) may be installed into...

Looking for a replacement horn driver for your PA speaker or monitor? The Eminence APT:50 is a replacement horn driver for use with the Eminence APT:80 horn. Bring back the high-end to your speaker with the Eminence...