ProX T-LS35C-Truss

The ProX T-LS35C-TRUSS is a set of three, 57" Triangle Truss (Bolt-on). Thse medium-duty triangle truss sections create a near 15 ft section span.  You can mount up to 200 lbs evenly distributed across the max lenth.  Truss tubes are 35mm - 1-3/8" in diameter.  Truss sections are 6-inches in overall width.  You can create a 57" near (5Ft) span all the way up to a 171"  near (15 ft) span; depending on your specific needs. *Stands and Crank System - Not Included*

Shipping Dimensions: 57" x 20" x 9" (per section)
Shipping Weight: 33 lbs
 

^{Exercise caution when loading this or any ProX truss system.  Be sure to evenly distribute your fixtures or equipment for safety. 
Always use a safety cable or chain on all mounted fixtures.}

^{SAFETY INSTRUCTIONS
To avoid problems a competent person should inspect all rigging hardware, stands and equipment before each use and periodically do a major inspection for signs of wear, abuse, and general adequacy, as well as perform any manufacturer recommended preventive maintenance on schedule.  Observe all warnings and usage instructions.} 

^{Basic Usage: Ensure that your stands are positioned on hard stable surface, in suitable location, on firm ground and clear of overhead obstacles.
Stabilize legs before lifting the tower or any load. When outdoors, secure the tower with braces or cables, in case of wind.}

^{Safety Notes:}

^{Loading on truss and stands should comply with rated weights.
Lock all the safety mechanisms (safety pins, knobs)
Loads must be centered & balanced on each lifting unit.
Safety chains must be installed on each item attached to unit.
Leave a safety perimeter with a radius 5ft greater than the maximum height of the stands during lifting and lowering of loads.
During transport, close all the sections and lock the lifting carriage.
Do not attempt to move the stand when loaded or in extended position.}