ProX T-LS31M

ProX T-LS31M lighting stands are a tough yet portable lighting solution that is ideal for traveling DJs, artists, performers, nightclubs or stage shows, constructed specifically with top-tier safety and performance in mind. ProX T-LS31M is built from metal components that will outlast any other lighting stand. This trussing system offers easy set-up and high stability for your professional equipment. It can also be used as a mounting system for a large format projector screen. It comes with two tripods that telescope to 12.5 feet, featuring two locking grooved pins. Also included are two T-bars with four mounting points each and two, five-foot trusses that securely lock together to create a ten-foot wide span, or be used separately. 

SAFETY INSTRUCTIONS
To avoid problems a competent person should inspect all rigging hardware, stands and equipment before each use and periodically do a major inspection for signs of wear, abuse, and general adequacy, as well as perform any manufacturer recommended preventive maintenance on schedule.  Observe all warnings and usage instructions in the full manual. 

Basic Usage:

1. Ensure that the stand is positioned on a hard stable surface, in a suitable location, on firm ground and clear of overhead obstacles.
2. Stabilize legs before lifting the tower or any load.
3. When outdoors, secure the tower with braces or cables, in the case of wind.

Safety Notes:

1. Loading on truss and stands should comply with rated weights.
2. Lock all the safety mechanisms (safety pins, knobs)
3. Loads must be centered & balanced on each lifting unit.
4. Safety cables or chains must be installed on each item attached to the unit.
5. Leave a safety perimeter with a radius 5ft greater than the maximum height of the stands during lifting and lowering of loads.
6. During transport, close all the sections and and tighten tube clamps
7. Do not attempt to move the stand when loaded or in an extended position.

Service Notes:

1. Servicing and repairs must be made by qualified persons.
2. Telescopic masts must be inspected before each use. Any damaged parts must be replaced immediately.