The Furman Merit M-8S Power Sequencer is a great low-cost AC power solution for any rack mount system.  Install an M-8S in your rack. and the eight outlets in the rear panel will power up in sequence and protect all your equipment up to a 15-amp load.

Power Sequencing - Prevents excessive inrush currents.

Noise Filtration - Noise filtering to reduce radio frequency and electromagnetic interference.

Surge Protection - Ensures equipment stays safe.

9 Total Outlets - Eight rear panel outlets and one front panel convenience panel outlet.

15 Amp Rating - 15 amp rating. with circuit breaker.

"Protection OK" Indicator - Front panel indicator LEDs for Outlet Banks. Protection OK and Power Status.

Wall Wart Spacing - Rear outlets have been spaced to accommodate even the bulkiest of wall warts and adapters.

Furman M-8S Features:

• Standard level AC protection and filtering
• Six sequenced rear panel outlets (in 3 groups). two unswitched rear panel outlets. and one front panel unswitched outlet
• Momentary and Maintained sequencing via rear panel terminal block or front panel switch (momentary only)
• All settings and configurations available on rear panel
• Three year limited warranty

Furman M-8S Specifications:

• Maximum Output Current: 15 amps. 120 VAC (Thermal breaker)
• Line Cord: 14AWGx3. 10 feet. black. fixed. NEMA 5-15P plug
• AC Receptacles:
  • Convenience Outlet (Front Panel): 1 Un-switched NEMA 15-5R
  • Rear Panel Outlets: 2 Un-switched NEMA 5-15R (1 duplex). 6 Sequenced NEMA 5-15R (3 duplexes. each controlled by separate relay)
• Standard level AC Surge Protection: Merit Class (sacrificial)
• Spike Protection Mode: Line to neutral. zero ground leakage
• Max Continuous Operating Voltage: 130V RMS
• Max Clamp Voltage: 500 Volts Peak
• Peak Impulse Current: 12.000 Amps
• Energy Rating (2 X 820¼S): 225 Joules
• AC Filtering: Standard level Pi LCR Filter
• Noise Attenuation: >26dB. 100 Khz to 1 MHz
• Operating Temperature Range: 5C (40F) to 40C (105F) degrees
• Humidity Range: <90% rH (Relative Humidity)
• Rocker Switch: Front panel. Sequence (ON. OFF)
• Thermal Circuit Breaker: Front panel. push to reset
• Front Panel Indicators: Delay 1. Delay 2. Delay 3. Power. Protection OK
• Rear Panel DIP Switches: 12V Mode On/Off. GND Mode On. Momentary/Maintained
• Potentiometer: Rear panel. time calibration fine tune delay adjust
• Remote Terminal: +5-30VDC In. 12VDC (12mA) Out
• Remote Terminal: Phoenix type 4-Pin Connector with Screw terminals; +12V. STAT. REM. GND (Class 2 Wiring)
• Dimensions: 19" L x 8.75" D x 1.75" H – ANSI 1RU
• Weight: 7 lbs.
• Power Consumption: 5 Watts
• Safety Agency: C/CSA/US